Last Modified: 11-29-2007 1.6 G
Service Category: Brake Section: Parking Brake
Model Year: 2008 Model: Sequoia Doc ID: RM000002ELJ005X
Title: PARKING BRAKE: PARKING BRAKE SWITCH: ON-VEHICLE INSPECTION (2008 Sequoia)

ON-VEHICLE INSPECTION

1. REMOVE PARKING BRAKE SWITCH ASSEMBLY PARKING BRAKE: PARKING BRAKE PEDAL: DISASSEMBLY (2008 Sequoia)+

2. CHECK PARKING BRAKE SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 - Body ground

Parking brake switch ON (Switch pin released)

Below 1 Ω

Parking brake switch OFF (Switch pin pushed in)

10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.

3. INSTALL PARKING BRAKE SWITCH ASSEMBLY PARKING BRAKE: PARKING BRAKE PEDAL: REASSEMBLY (2008 Sequoia)+